Random good picture Not show

61. The simple determination of specific surface area for porous solids by ethanol - desiccator method is described.

62. Results showed that compared with porous SiC ceramics, the MOR of SiC-cordierite was improved significantly, and the TEC decreased remarkably, and the apparent porosity also decreased.

63. The friction performances of laser - textured porous seal face were experimentally investigated.

64. That border is extremely mountainous, winding, and porous to foot traffic back and forth - posing a constant challenge for military planners on both sides.

65. Porous analcite balls are prepared by analcite rocks andand then are used to removing fluorine.

66. Methods:the porous discs of PHEMA were implanted into interlamellar pockets.

67. The constructive diagenesis are mainly epigenic karstification and burial dissolution. The destructive diagenesis are filler in each periods(sentencedict .com), the most devastating cement to porous is sparry calcite.

68. The apparent reason for this is that the surface is so porous that an impacting space rock causes little ejecta , material blasted out of the collision site and is scattered all around.

69. Firstly, the sintered metal porous material is determined be used for rectifying tube after the experiment comparison of 4 types and 6 kinds of porous materials.

70. The final structure of porous membrane is decided by the diffusion speed of supercritical CO2 fluid inside the polymer and the plasticizing effect of polymer caused by supercritical CO2 fluid.

71. Porous adonic aluminum oxide templates are widely used to fabricate nanowires or nanotubes of many materials.

72. This quantity describes the retention of particles in a porous substance.

73. The porous Co-Cr-Mo alloy material are used as got-up active bones.

74. An algebraically explicit analytical solution for governing equations of heat and mass transfer process in wet capillary porous media is derived.

75. This experimental study focused on the sediment trap effect of porous check dam and closed type check dam.

76. PAN - based carbon membranes were prepared using dip-coating method, in porous coal - based carbon tubes were support.

77. For continuous seepage in porous media, the free surface of seepage can be determined by initial flow rate method. The said surface is a continuous curve.

78. A new type of porous sound absorbing material was made from - strength gypsum and glass fiber.

79. The product is made of high quality low-carbon steel with sintering porous bronze as its interlayer, with the compound of POM as its surface.

80. A generalized equivalent - continuum method is presented for calculating variably saturated seepage flow in fractured porous media.

81. A thick porous chalk subsoil covered with marl, clay or sand.

82. The shapes then further organize into a crystal lattice that resembles a porous structure called zeolite, an absorbent material with many industrial uses. Credit - Michael D.

83. SiC/C binary porous green body was prepared by electrophoretic deposition process, using 70%water-30%alcohol as dispersion medium, and silicon carbide and petroleum coke powder as starting materials.

84. In practice this is done on an enlarged photomicrograph of the porous medium.

85. The effect of different process . conditions on the porous carbonaceous adsorbents prepared by pyrolysis.

86. Foam silicone rubber is a typical porous material whose constitutive behaviors are attributed to the hyperelastic properties.

87. Typically, these membranes are MADE from porous carbon, zirconium oxide, or alumina, although a wide range of materials are being tested.

88. Porous ceramics may be used as high-temperature filter, catalytic carrier, porous electrode for fuel cell, and bioceramics, etc.

89. The blood compatibility and cell compatibility experiments disclose the latter porous calcium metaphosphate glass ceramics have good biological compatibility.

90. Expanded graphite is a soft porous material which is produced by natural squama graphite by means of oxidation , inserting, watering, dryness and expansion.