Random good picture Not show

151. Keep the F. O piston valve open not in excess of 10 seconds max.

152. Pump speed in rpm determines the pumps output volume for any given combination of cylinder bore and piston stroke.

153. The plasma nitriding will improve on surface hardness and wear resistance of the piston ring.

154. The top of the piston is shaped to give the incoming mixture an upward movement. This helps to sweep the Burned gases ahead and out through the exhaust port.

155. Aviation benzine is used at piston aviation engine, use quantity is less.

156. Aiming at how to reduce the pump noises, a new type of double acting piston radial pump with lower noises is designed here.

157. The influence of surface texture parameters on piston ring lubrication performance was obtained by solving the mathematical model with multi-grid method.

158. A method of applying the coating to the piston skirt is also disclosed.

159. Using the moving grid technology, the influence of a particle in oil film in a cylinder on piston ring lubrication was investigated.

160. The actual volume of material dispensed is determined by the piston displacement from this stage.

161. The results show that: The new Rack-Clutch Engine is composed with the power unit, which has the full name of Opposed Piston Engine with"Rack-Over Running Clutch"Mechanism.

162. Diesel engine: Internal-combustion engine in which air is compressed to a temperature sufficiently high to ignite fuel injected into the cylinder, where combustion and expansion activate a piston.

163. The paper mainly introduces the calculating equation for piston skirt molded lines, the drawing of piston, and the design for convexity mother plate molded lines.

164. This graduation project which is commissioned by a large motorcycle (Group) Co. , Ltd. as an application issue, is to developing the Piston Rings Full Automatic Assembly System.

165. After use for a long period, the push rod can push and pull with no-load, cannot push and pull with load, replace the sealing piece used for the upper hole of piston in the oil cylinder.

166. The leak detection quality assurance system involves a uniquely designed port in the piston head between the main piston seals; this system immediately signals any compromise of the seals.

167. The preliminary research showed that the material used of the piston rod is unqualified , casting aliquation and much S element result in cracking on the edge of the casting aliquation.

168. Abstract Straight columnar piston type stapes prosthesis is commonly used in stapedioplasty.

169. Based on these theories,[http://Sentencedict.com] designs a new type of corerpressure piston corer ( PPC ) .

170. Basically, this compressor is not in the oil cylinder, the piston ring and packing usually PTFE.

171. As soon as rotate piston compressor be concerned, considing the thickness of slider and inference the change rule that the basic capacity of intake cavity with rotate angle.

172. The utility model provides a pneumatic conveying device, which includes a cylinder body, a piston rod, a piston seal, air storage chambers on two sides, a reverser, and each inside passage.

173. The plating parameters determine the quality and corrosion - resistance of chromium plating layers of piston rods.

174. Combustion noise and the piston knock noise are separated by adopting sound pressure method.

175. Metallic detergent and ashless dispersant additive system provides superior control of ring belt and piston skirt deposits, even under the most severe operating conditions.

176. Heat is thereby converted into mechanical energy of the piston.

177. The results of calculating and experimenting show that the first and largest slap of impact between the piston and the liner occurs around the top dead center from the nonthrust to the thrust face.

178. Step 1 – The piston is in the up stroke position and material is allowed to fill the piston chamber.

179. The paper analyses the necessity for piston in modern auto to adopt non circular pin hole.

180. This applet demonstrates the effect of pressure by considering a gas particle in a frictionless piston.