Random good picture Not show

1) Heat exchangers might also benefit from treatment with polymers.

2) It is thus possible that the two exchangers have distinct functional roles and are selectively regulated.

3) The joint effort has produced remote control fuel-rod exchangers and automatic inspection systems for radioactive welded pipes.

4) After the water plate heat exchanger should be met.

5) Develop price calculation software for heat exchanger product.

6) Heat pipe exchanger is an efficiently change hot device.

7) Expanding heat exchanger coil's hairpin tube copper tube.

8) Fouling detection for plate heat exchanger?

9) The breech lock closure type heat exchanger is characterized by reliable sealing performance, easy dismantling and assembling, high utilization ratio of heat exchange area and small grounding.

10) The tube blocking of graphite heat exchanger is attributed to the solid gypsum in dilute phosphoric acid and the scars in the concentration process.

11) The anti-freezing heat exchanger is arranged in a drain pan.

12) The structure and performance characteristics of shell heat exchanger corrugated plate are introduced.

13) The joints behave as the conduits of a subsurface heat exchanger.

14) The United States is the second most popular destination for its exchangers,[http://sentencedict.com/exchanger.html] representing about 20 percent of houses listed.

15) The water rises, the heat is transferred to heat exchangers and the water then returns below ground to be reheated.

16) This can sometimes be avoided by the use of a newly developed stent exchanger.

17) The working principle of a bootstrap air cycle refrigeration components is described in detail, such as compressor, turbine, shaft and internal heat exchanger.

18) A single U-tube is the most common type of ground heat exchange in Ground Coupled Heat Pump (GCHP) system, and ground heat exchanger is an important component of the GCHP system.

19) In the design of ground-source heat pump (GSHP), the inlet water temperature and velocity of the media in the underground U-tube heat exchanger are very important for heat exchange rate.

20) The importance of the balance of heat absorption and heat-removal in the operation of the HGSHP's ground heat exchanger was pointed out.

21) The design and research of the paper has certain reference value to shell-and-tube heat exchanger especially U-tube heat exchanger engineering design.

22) Tube arrays can be found in the area of heat exchanger, solar collector, electronic cooling and electrodes used in the plating bath.

23) Measure the cooling air side static inlet pressure (P) in inches of water at the heat exchanger inlet on the pressure indicator. Refer to Table C.

24) The paper put forwards the way of extracting refining stevioside by boiling water from the leaves of stevia rebaudiana bertoni and removing impurities from extract by alcohol and ion exchanger.

25) Flush product stream outlet to blowdown or pumpout system to water free the line and exchanger.

26) Experiments of heat transfer and pressure drop in a corrugated plate air-cooled heat exchanger were conducted with variable supply air and hot water flow rates.

27) Heat transfer enhancement was investigated in a coaxial - pipe heat exchanger using dimples on the inner tube.

28) The method can be used in fast reactor safety analysis and simulating calculation of velocity and temperature in heat exchanger of industry.

29) Equations of rate of exergy loss for shell and tube exchanger are derived.

30) Flush the hottest stream inlet blowdown or pumpout system to water free the line and exchanger.