Random good picture Not show

61. Karayulgun dextral strike-slip fault, which is a thin-skinned structure, adjusted the deformation difference located at frontal range of Quele area.

62. Based on the pseudo-static test of four slit hollow shear wall models of reinforced concrete with different steel bar, the failure mechanism and deformation feature are discussed.

63. In-situ deformation tests are made at 35 points in the unloading zone with conditions of loading path and the maximum pressure similar to that of the arch dam acting on the rock mass.

64. The deformation of level foundation is generally symmetric of road central line and the deformation of slope foundation is mainly concentrated on the border side of the declivity.

65. According to Hertz contact theory, this paper discussed the elastic deformation in the ball screw systems and elastic potential energy caused by it.

66. Because of structural steelwork easy deformation in steel structural glass is not that simple.

67. Meanwhile, the calculated deformation of the rear fork structure was applied as the welding pre-deformation to the actual production process, in which qualified products were produced.

68. In this paper, the application of laser techniques to observing tilting deformation of multistorey buildings and chimneys is presented.

69. It is difficult to inject steam into cold production wells because of casing deformation resulting from well cementation difference between cold production and thermal production.

70. BS - DD 226 - 1996 Method for determining resistance to permanent deformation of bituminous mixtures subject to unconfined dynamic loading [ S ].

71. Punching is a kind of pressure process method that punching dies are used in press sheet to put pressure on the plastic deformation or separation, for a certain shape and size of components.

72. In this paper the morphology of the ferrite twin deformation, the conditions of a thick twin crystal formation, and the various factors to decide the quantity of twins produced are analyzed.

73. The linear film is the key to make plate, subject the network deformation of positive film, is meaningful to do the normalization and standardization of making film or plates well.

74. The differential salt tectonic deformation is mainly represented by structural differentiation at different levels, and structural zonation and segmentation in transverse and longitudinal sections.

75. So it is feasible to study the deformation behavior of sheet metals along different loading paths by using biaxial tensile test of cruciform specimen with slots on arms designed in this paper.

76. Higher lateral deformation and Poisson's ratio as well as negative volumetric strain can be reached for higher pore pressure even though axial strain of specimen is lower.

77. By outcomes of latest theory research, the direct formula about dilatancy angle and surrounding ground deformation is introduced.

78. Structure analysis showed that the incoordination in deformation process of two phases is the main reason why microcrack occurs at phase boundary.

79. A method is presented for dynamic analysis of walking vehicle system with large gross motion, small elastic deformation, and discontinuous boundary constraints.

80. The influence of groove fillet radii of vertical rolls on cropping and margin deformation of slab were analyzed.

81. The ratio of the magnitude of an applied shear stress to the velocity gradient that it produces; that is, a measure of a noncrystalline material's resistance to permanent deformation.

82. The reason of deduces deformation martensite in the drawing process is analysed also.

83. Finger is the important component of automobile engine rotor, whose centrifugal deformation is the key element affecting engine interstice.

84. The product can be directly made into flat thimble without warping and deformation.

85. And so there is deformation,friction effects,[Sentencedict.com]tidal effects and so on.

86. The deformation was changing from plastic intensity to weakness and the metamorphic facies ranged from amphibolite to low-grade greenschist.

87. The effect of base structural deformation on inherent frequency of a microbeam resonator is analyzed by using analytical method.

88. Accelerating the construction of concrete cushion as soon as possible can make full use of bracing effect on controlling the lateral deformation of retaining wall.

89. We shall present certain introductory notions that pertain to finite deformation in this chapter.

90. This paper advanced a study method that can observe plastic deformation behavior of surface layer of die cavity by showing austenite grain, size, crack morphology and propagation mode.