Random good picture Not show

91. Silicon epitaxial planar transistor, for use in audio and general purpose.

92. The circuit also includes a second subcircuit that causes a second transistor (25) that is coupled to the circuit's output (34) to turn on during a falling transition and then turn off.

93. Today, the usual low noise design is to chose transistor and its quiescent point in order to ensure that the noise resistance equals the signal source resistance.

94. A transistor circuit for an array device comprises a plurality of thin film transistors electrically connected in parallel and provided on a common substrate.

95. The sleep transistor circuitry is coupled to the first circuitry and receives a sleep signal that has a negative voltage.

96. Brattain : american physicist. He shared a 1956 Nobel Prize for developing the electronic transistor.

97. Thank you for your inquiry of September 23 concerning transistor radio sets.

98. A hetero-structure field effect transistor (HFET), may include a first layer (3) made from a first semiconductor material and a second layer (4) made from a second semiconductor material.

99. The welding quality between the chip sad the base of power transistor inspected by radiographic testing was described.

100. World's first semiconductor rectifier and the transistor is, when no power semiconductor or microelectronics semiconductor division.

101. An NPN transistor can be considered as two diodes with a shared anode region.

102. Throughtuning the grid-voltage of MOS transistor, we can tune the equivalent resistance, accordingly tuning the cut-off frequency of the filter.

103. A transistor has three electrodes, the emitter , base and the collector.

104. Metal wire bonding interconnection is the key means in the internal matching technology of RF power transistor.

105. Silicon epitaxial planar transistor. High power, high frequency, audio and general purpose.

106. This paper describes the unload circuits which are used in power transistor (SOA). RCD unload circuit and a novel unload circuit without energy losses are presented, their effects are discussed.

107. In a drive system of power transistor inverter-motor, not only can it be used in fine control of motor current waveform, phase, amplitude and frequency, but can also be used to sense,(www.Sentencedict.com) fault current.

108. A depleted NMOS transistor, which was used as current source, and a negative feedback loop constitute a stable voltage reference.

109. An effective way to reduce the leakage power is by means of multithreshold CMOS technique, which can restrain the leakage current by adding a MOS transistor to low threshold circuit.

110. Using these expressions numerical calculations were carried out for two types of commonly used transistor Schmitt circuit.

111. Major conclusion is: it is possible to achieve ideal vertical PNP transistor by appropriately re-arranging process steps without affecting the original structure.

112. Each of the individual transistor cells includes a body region located on the substrate, which has a second conductivity type.

113. Digital Logic Isolation. Line Receiver. Power Supply Control Feedback Control . Switching Power Supply. Transistor Invertor.

114. They are used for gating and also as current limiting for the base of each transistor.

115. The welding quality between the chip and the base of power transistor inspected by radiographic testing was described.

116. The factors of MOS transistor in the saturation region are analyzed, the mismatch models are optimized, and the model parameter extraction is done by least squares curve fitting method.

117. In chapter 4, the circuit of the carrier synchronization unit is implemented on FPGA, the Resistor Transistor Logic (RTL) schemes are presented.

118. Switching time of the new - type transistor is shortened five times.

119. The transistor pulse generator power supply is now commonly employed as a UEDM power supplier.

120. Transistor amplifier circuit has oscillation preventing diode connected to connecting wire of 2 transistors to prevent inductance due to wire length.