Random good picture Not show

91 The calculational formula for cell compressive force was (obtained) expressed by cell girth and by node coordinate and displacement of plant cell mechanical models.

92 Usually the compressive force is in the form of hammer blows using a power hammer or a press, as shown in Fig. 4.1.

93 The study result shows that the Hall coefficient(absolute value)of n-Si samples will decrease with the increase of compressive stress.

93 Sentencedict.com is a sentence dictionary, on which you can find nice sentences for a large number of words.

94 In the eastern area, the tensile strain is very intensive, while the compressive strain is very weak.

95 Neurilemmoma showed compressive bone change, cystic area and moderate enhancement on CT.

96 It is used for low compressive strength and exceeding soft formation of high drillability, such as, shale, clay, sandstone, soft limestone, halite, gypsum etc.

97 It is also shown that the residual stresses are compressive below the surface and tensile in the center, and the minimum of local residual tensile stress occurs at the midplane of the plate thickness.

98 This process will bring the glass surface compressive stress and the interior tensile stress which can improve the mechanical strength of glass by gemination and result in good thermal stability.

99 The compressive end resistance and tensile resistances of the plate are compared with each other.

100 The mechanics behavior of membrane material under residual stress and compressive stress has been studied.

101 Compressive strength reduction in compression zone is one of the main factors which affect surplus bearing capacity of corroded reinforced concrete eccentric compressive components.

102 Results show that the density and the compressive strength increase with an increase of the average (particle) size of granular pitch coke.

103 Destruction mechanism of rock included crack under compressive stress condition had been discussed.

104 Compressive strength, splitting strength, flexural strength, compressive resilience modulus and flexural resilience modulus of cement stabilized stone of different structure types were tested.

105 Influence of hot-pressing time, temperature and pressure on the porosity and compressive strength of the scaffold.

106 A unified numerical expression of the compressive stress - strain curve applicable to concrete is put forward.

107 The paper trys to analyse stability of column by the method of dynamic analysis, deduces the formula of relation between axial compressive force and frequency of transverse vibration.

108 The films have advantages of slightly compressive stress, very low pin-hole density and superior step coverage.

109 The method of cold work hardening is applied to increase the permanence limit and to decrease the compressive stress of groove and little round angle of turn angle on mechanic components.

110 The attribution and changeable tendency of stress on the lower surface of T12and L1under axial compressive load of800N in the two models were comparatively analysed.

111 If this work piece is held between the centers of the lathe, the centers exert a compressive force against the work.

112 There was no direct relation between residual compressive strength and impact damage area.

113 ResultsThe changes of intervertebral loads in the adjacent segments made the compressive load increase in the proximal segment after the discectomy.

114 In addition to these, the influence of area ratio , negative overlap, compressive factor and load inertia on system behaviors are also analysed.

115 The second tube (16) is configured to generally remain open in the absence of an externally applied compressive force.

116 The compressive modulus of Elasticity of the butanone rubber gasket are given, based on the compressive test Value of this type gasket, with the analysis and inference method by the authors.

117 Both compressive strength and tension strength of test specimens cured with CM-A are equal to or a bit higher than that with wet burlap.

118 The high temperature compression strength was researched using high temperature compressive testing machine with adjustable atmosphere.

119 Stress-strain curves show that the ranges of compressive stress and the elastic modulus of mortar decrease with the increasing strain after mixing waste rubber powder.

120 In addition to these, the influence of area ratio, negative overlap, compressive factor and load inertia on system behavior are also analysed.