Random good picture Not show

211) The bending of simple supported beam make the resonance peak wavelength of each mode of TFBG shift and resonance peak amplitude unchangeableness.

212) PB films are stored near to bending furnace ( high temperature ).

213) First, the paper deduces the formulas of plate plane stress problem and plate bending problem, and studies the method of region coupling of above two problems using the region division technique.

214) A ballast intended to be supported only by rigid metal conduit, a fixture stud, or similar devices shall comply with the requirements in Section 18, Pullout, Bending, and Twisting Tests.

215) Nonlinear bending of an annular sandwich plate under the action of a line load uniformly distributed along the inner edge is discussed.

216) On a psychokinetic level back bending moves one into the future. (forward bending takes us into our past).

217) The change of strip crown is in direct proportion with work roll shifting distances and roll bending force and the square of strip width.

218) Using CHAMP observational data samples, the profiles of atmospheric bending, refractivity, pressure, and temperature were retrieved in tern by the series of signal noise ratio.

219) Aronson said the key to his robotic bending cell is that a nearby press brake operator oversees a manual brake and the automated cell.

220) But the bending moment at the central hinge must vanish.

221) The lower balance force with balance factor 0.89 is adapted to reduce bending of universal coupling shaft and load of copper slider.

222) Having been detained for more than 16 months in American prison,(www.Sentencedict.com) the middle-aged and humpbacked Alex is now bending more.

223) The bird was enclosed in such a small space that it could not turn without bending its tail.

224) The effects of the connectors on the critical buckling load and the bending stress of pipes in horizontal section are analyzed.

225) Mechanical characteristic of CT is studied. The model of bending, internal pressure strength and external collapse strength, diametric growth and stuck-point of CT is established.

226) Based on the calculation results of beam-spring model, the logical value range of segment ring's effective ratio of bending rigidity and increasing rate of moment have be made out.

227) With bounce-back DNA in the palm trees, they come right back up from bending to the ground after the hurricane is gone.

228) CNC Hydraulic Press Brake offers Conic Bending a maximum of 15 mm along the whole length.

229) He was bending over the pool netting tadpoles with a sock, his trousers rolled up.

230) The principle and methods estimating bending angles of the radio rays and atmospheric refractivity profiles with the mountain-based radio occultation data are given.

231) The mechanical automation of bending technique is the troublesome problem to car′s manufacturer.

232) The branches were bending down with the weight of the apples.

233) By using the complete standard of dbase system, the unfolding result of blank bending parts can be obtained quickly and exactly.

234) Profile with bigger section modulus of bending will be more difficult to bend, and the bigger the distance from neutral surface to the axis of the roller, the smaller the curvature radius.

235) Bending of stitching can't exposed Sticking foxing and vamp sketch line smoothly.

236) This paper reported the bending strength improvement with relation to cobaltic phase structure of laser heat treatment in the surface of cemented carbide.

237) Meanwhile, the springback potential energy principle is applied to calculate the springback deformation of a pure bending of curved beam.

238) Analyzed factors affected springback in beam bending forming, elaborated how to springback compensation in die design process, introduced the die working process.

239) The new running-in specifications of transmission, having the strengthening effect, was estimated by the results of strengthening under low amplitude load of single tooth bending of cylindrical gear.

240) This thesis establishes the quantitative descriptive model of mathematical analysis in V-shape free bending of wide sheet metal by using theoretical analysis method.