Random good picture Not show

121. The paper describes some key technology of design circuit and craftwork on developing High-power set up power of aluminum air battery , presents the application of the Step-up power.

122. Above results will be helpful to improve the aluminum ingot machine.

123. The micro - volume of aluminum electrolytic capacitor has been development of microelectronic technology.

124. Taken in excess, aluminum - containing antacids cause hypophosphatemia, which may lead to metabolic bone disease.

125. Material: high quality low carbon steel wire, stainless steel wire, aluminum alloy wire, PVC wire.

126. Inside the machine shop, a cart is overflowing with aluminum shavings.

127. Aluminum, copper, and the alloys, Bronze and Brass,(www.Sentencedict.com) are common non - ferrous metals.

128. Because aluminum ions have charge of plus three and oxygen ions have charge of minus two.

129. Mainly used for welding stainless steel, aluminum, copper and some ferrous metals.

130. The simulation experiment of refining aluminum melt out using the spinning jetting device made by ourselves.

131. Structure and performance of aluminum impregnation to steel _ container are studied.

132. Diffuser disc is produced from aluminum oxide and ceramic bonded together with high sintering temperature.

133. The novel - flocculant poly - nucleate aluminum hydroxy silicate - sulphate ( PASS ) was prepared and polysilicic acid under non - high shear condition.

134. The present situation of application and study of master alloy refiners in aluminum alloys was reviewed in this paper.

135. Aluminum foil in pharmaceutical packaging is used primarily for blister packaging.

136. Anodic aluminum oxide ( AAO ) was fabricated on aluminum in acid electrolytes at constant voltage.

137. Design consultation and manufacturing of spring aluminum landing gear and aviation composites.

138. The third feeding for tretle type, only put the aluminum foil.

139. Fly ash particles act as viscosity increaser wall in the aluminum foam.

140. The principal ore of aluminum , composed mainly of hydrous aluminum oxides and aluminum hydroxides.

141. In this paper, aluminum - scandium alloys were prepared starting form scandium oxide by molten salt electrolysis.

142. A self-made directional solidification furnace was used to fabricate high purity aluminum(HPA) ingots, and the morphology of grains was studied.

143. A flow chart of aluminum processing waste stream is presented in Figure 22.

144. Step 3 : If the aluminum foil ball is repelled away from the dish, the electroscope works.

145. Made compendious introduction to the aluminum foil industry of Germany and France.

146. It's a chlorinated rubber coating with aluminum flake pigment. Physically drying.

147. The intrinsic self regulation effect of aluminum alloy wire in the region of short arc in MIG welding is investigated with self made equipment.

148. Middle sized fireproof aluminum ball is used to ensure the applying strength.

149. Also the process of hydrogen evolution during cathodic half cycle played a dual role (i. e. promotion and impediment) in anodic pitting during AC etching of aluminum.

150. Calcinating this salt at 1200 C results in its decomposition into alumina ( or aluminum oxide ).