Random good picture Not show

31. The concept of the custom binding provider is introduced here to define a declarative model that can be used to plug in a set of custom binders to either emitter tools or a run time system.

32. UV unit: High speed low pressure UV emitter; UV sensor with alarm.

33. A high-voltage pulse generator with adjustable pulse width is described, which is designed based on common emitter transistor circuit and common base transistor circuit.

34. A transistor has three electrodes, the emitter , base and the collector.

35. In this case the emitter resistor is 10K, and the typical gain of the 2SC1815 is 300, for an input impedance of 3M at the transistor base.

36. The system uses the emitter to send ultra high frequency signals after coding with signal coder and the secondary superheterodyne mixing receiver to accept the moving target signals.

37. A new design of BJT analog switch using high speed unit such as emitter follower, current mirror and unsaturated current switch is presented.

38. An LED light source includes an LED emitter and an encapsulant that at least partially surrounds the emitter.

39. Measurement results of impurity concentration show that implanted P element distributes mainly in collector region and has no obvious influence to the impurity distribution in emitter and base.

40. Moreover, the collector of switching transistor is also connected to an output end of PG signal directly. The emitter is also connected to an input end of a control signal directly.

41. The main topic in the thesis is the coupling the coupling between the high power single emitter broad area diode laser and micro lensed multimode fiber.

42. If you plan to enable event monitoring of SCA components or handle events emitted by the Event Emitter primitive, you can perform post-installation tasks to configure the Common Event Infrastructure.

43. Since the structure can be easily prepared, and its components are widely selectable , and its surface stability in mechanics and chemistry is outstanding, this structure is an ideal electron emitter.

44. Recombination occurring in the emitter region of a photovoltaic cell.

45. Diamond is a material of negative electron affinity, which can be used to fabricate electron emitter in FED (DFED) to reduce the work function, hence reduce the working voltage.

46. A collector or emitter of electric charge or of electric - charge carriers , as in semiconducting device.

47. The deinterleaving of radar emitter signals is a crucial technique in signal processing of Electronic Intelligence, which directly determines the performance of electronic reconnaissance equipment.

48. The earliest IC op amp OUTPUT stages were NPN emitter followers with NPN current sources or resistive pull-downs, as shown in Figure 1.6.

49. The basic structure of the circuit is two stage cascade, in which were a CE (common emitter) structure as input and a Darlington structure as output.

50. Finally decoded signal controls seven light emitter diodes ( LEDs ) through a 74 LS 138.

50. Sentencedict.com is a online sentence dictionary, on which you can find excellent sentences for a large number of words.

51. The electron emitter has carbon particles and metal oxide particles.

52. We have been considering the transistor with a current fed into the emitter.

53. The simulation results show that the emitter injection is easier to burnout the BJT than the collector injection, and the base injection is relatively difficult.

54. At a higher injection level, the current amplification factor drops off as the emitter current density is increased.

55. Ultra bright emitter. Fiber optics. Bar code scanning. Water clear. Peak emission wavelength 660 nm.

56. China, now the world's biggest emitter working on both parallel.

57. Differential switched emitter follower and low-droop output buffer were combined to improve the circuit performance.

58. The common emitter configuration is by far the most versatile and widely used.

59. The gated silicon field emitter arrays(FEA) with small gate aperture have been successfully fabricated by dry etching, including ion beam etching(IBE) and reactive ion etching(RIE).

60. The conductive layer has a first conductivity type emitter diffusion layer in contact with the emitter electrode through the protruding portion and a second conductivity type base layer.