Random good picture Not show

1. In this paper, a bi-mass model of metal V-belt type CVT system is established, and its dynamic characteristics have been studied in both theory and experiment.

2. V-belt configurations generally must be manufactured in special sections for dual drives.

3. The motorcycle V-belt continuously-variable transmission controlled by centrifugal ball is analyzed, and the method to obtain the pressure angle of the wimble surface on the moving disk is gained.

4. The key elements of evaluation for designing V-belt transmission were specified together with the corresponding qualification and the normalized qualification.

5. The V-belt drive took place of the direct connect drive was the main modification measure.

6. The V-belt equivalent coefficient of friction indicates that the bearing capacity of Vbelt is higher than that of flat belt.

7. Revolves, canned, the V-belt pulley organization, the cam gear, the crank slide, the bevel gear.

8. PK multiple V-belt is applied as transmission belt to resist wear and abrasion and avoid troubles like belt creep and noise caused by traditional belt transmitting system.

9. So it is very important for rolling process of V-belt pulley to control metal flowing on tangential direction.

10. On the basis of the general design, this paper studied reliability optimal design of V-belt transmission.

11. The wheel system for automobile engine accessories consist of the compressor, power steering pump , air filter , generator , etc. which linked by a V-belt or poly_rib belt.

12. The development history and current technology status of Metal pushing V-belt type CVT about domestic and overseas are reviewed in this dissertation.

13. The steel ring is the key component of metal V-belt,[sentence dictionary] its main failure is fatigue rupture.

14. The shortages of the direct-connected gear reducer of paper-guiding roll in the third press are discussed. The V-belt drive took place of the direct connect drive was the main modification measure.

15. The work takes into account new findings in other research and changes in the design of the metal V-belt.

16. This paper proposes a one-dimensional continuous model of the steel pushing V-belt, which describes the shifting dynamics of the CVT transmission during rapid speed ratio variations.

17. Athree-phase A. C. motor is adopted in this machine to drive, through a worm wheel reducer box and a V-belt, the guilder which drives the cloth swing trunk by a pair of gears.

18. The utility model is a special mold for producing a V-belt pulley, which relates to a mold.

19. And in accordance with the requirements of customers booking all kinds of special specifications V-belt, rubber tube.

20. The work spindle get four-grade rotate speed, which is driven by a couple of two-grade v-belt pulley.

21. The dissertation mainly deals with the research and developing work of numerical control V-belt cutter.