Random good picture Not show

1. This procedure creates a homogeneous austenitic microstructure.

2. Tensile properties and microstructure of the first loading region, last region and transition region of TA15alloy parts with different local loading were studied by experiment.

3. Effects of cooling rate on eutectic microstructure of Zn - ( 0.24 Ni ) alloy for hot dip galvanization were investigated.

4. The filling process, microstructure and mechanical properties of A 357 alloy was studied by low pressure casting.

5. Microstructure and histochemistry of the head-kidney of the carp were investigated by light microscopy.

6. The microstructure evolution of Q235 plain carbon steel in multi-pass hot deformation was investigated by means of hot compression simulation.

7. The results show that the microstructure of the alloys system is the compound of the acicular martensite and partial residual austenite. From the matrix, the composite carbides were precipitated.

8. The result shows that microstructure of clinker is various from different grinding system, and their burnability is also various.

9. The microstructure of Inconel 718 chip is continuous under low cutting speed and serrated under high cutting speed because of adiabatic shearing.

9. Sentencedict.com is a sentence dictionary, on which you can find excellent sentences for a large number of words.

10. The variation of microstructure and mechanical properties of the welding heat-affected zone of 2090 Al-Li alloy were investigated by means of the welding thermal, simulated and strain cycles test.

11. With the aid of uses the close microstructure the surface mounting seal single gate or the trigger then achieves the goal.

12. Microstructure, properties and fracture surface of high strength titanium alloy TB 2 cross - rolled tube were studied.

13. The characteristics of microstructure of the inverse chill in ductile iron are presented. The cause of the formation of inverse chill and its prevention are discussed.

14. The influence of alloying and spheroidization process on microstructure and mechanical properties of UHCS is investigated.

15. Several typical microstructure defects of chilled cast iron tappets, the reasons to cause, their formation as well as prevention measures were described.

16. Recrystallized microstructure and mechanical properties of cold worked brass annealed by electropulsing and routine annealing were studied.

17. The sulfides can refine the microstructure due to their pinning effect, and the reefing effect shows Zener relation.

18. The microstructure of commercial ultra - fine grain steel with plain carbon composition was analyzed.

19. The chemical compositions of new cast alloy steel with high Si content was designed, its microstructure and corrosion behavior were studied.

20. The results showed that the iron with Co addition had the more nodule count and most ferrite in the microstructure, and better toughness but lower hardness.

21. The acid proof and high temperature resistance was tested, the microstructure of end product of geopolymeric cement was analyzed by means of XRD, SEM and DTA.

22. A study on some physical properties on metallization of diamond surface and fractography, microstructure the relationship between diamond and metal material phase by the JCXA-733 electron probe.

23. The bulbar conjunctiva was obtained by impression cytology, and the microstructure of conjunctiva was observed under the scanning electron microscopy.

24. A support material with low expansivity and high conductivity, called DG alloy, was prepared by powder metallurgy. The effects of sintering process on its properties and microstructure were studied.

25. Firstly, the chemical compositions of D406A steel, the non-metallic inclusion and microstructure were tested, and their effects on the fracture toughness were analyzed.

26. Thedistribution relation of the width of early wood, transition wood and late wood versus thenumbers of growth ring was achieved by observing the microstructure.

27. Pipeline steel adopting the spicular ferrite owns the better properties of forming and anti corrosion for its low ratio of yield strength and tensile strength and uniform microstructure.

28. To quench 20 steel in critical zone under different intensity alternation magnetic field and to observe the microstructure after phase transformation.

29. The influences of adding addition agent, such as slag and cement, on the microstructure and properties of gypsum composites were investigated by means of SEM analyses.

30. Through the rolling experiments, the influencing regularity of the rolling starting temperature and the rolling reduction on the microstructure and the mechanical properties has been obtained.