Random good picture Not show

1 Don't superheat the anger of the mass. Otherwise you will not be able to control them.

2 Violence, insults, and superheated propaganda obstruct this end.

3 A blast of superheated rock fragments heralded the Doctor's arrival into a huge circular chamber.

4 Otherwise, the solidification structure for different superheat was simulated.

5 To lower the superheat of liquid steel, a water-cooled nozzle is designed to be used into commercial run in the paper.

6 The container may burst up if you superheat It'so much.

7 Now,[www.Sentencedict.com] Our country Government partial superheat and "the froth" the tendency has made the enough value to the real estate market.

8 Has designed one boiler superheat vapor temperature online fuzzy PID double model control method based on this, and has given the detailed design proposal.

9 The effect of the superheat is much slighter than that of above mentioned factors .

10 Superheat treatment can change state of the melt obviously, consequently affects the final structure and properties.

11 Furthermore, casting speed,(sentencedict.com) superheat and cooling waters effects on steady temperature field are analyzed in this paper.

12 Vapor-liquid heat exchangers are often used to superheat the suction vapor of compressor and to subcool the inlet liquid of throttle valves in refrigerating system.

13 The effects of different casting speeds, degree of superheat and secondary cooling to the central and angle part temperatures and the final solidification point have been studied.

14 Maximum wall superheat does not always exist at the top of the boiling surface.

15 It is shown that the degree of superheat of molten steel and the deoxidation alloying are main factors for the formation of skin blowhole.

16 In the superheat cycle, the saturated dry steam leaving the boiler drum is further heated before entering the turbine.

17 There easily exists shrinkage porosity due to superheat of ingate root in large plain parts investment casting.

18 The step response method of the outlet superheat of evaporator is measured by conducting experiments, and dynamic model of EEV is established by LSE(least square estimation).

19 Main control methods for intermediate-point superheat degree include water-fuel ratio control, enthalpy control, first-stage superheater spray correction, feedwater mild correction.

20 Pressure keeps the hot water from steaming or boiling; it becomes superheated, reaching temperatures of 350oC and more.

21 Using developed dynamic drop technique(floating droplet method), we measured the limits of superheat of n-pentane and n-heptane, n-nonane systems of binary n-alkaline mixtures.

22 However, excessive P addition results in a larger degree of superheat of the melt, hence aggravating the oxidation.

23 The relation of bubble nucleation rate and degree of superheat, and phase change driving force and phenomenological coefficient, were analyzed based on phenomenological theory, respectively.

24 The experience was conducted using cooling slope and low superheat processes, effects of pouring temperature and the degree of slope on the billet's structure were researched.

25 The vapor explosion discussed in this paper is defined as a kind of physical explosion that takes place when liquid is violently gasified under large superheat, causing the rapid increase of pressure.

26 The results show that the steel liquid is cooled down by cooling roller and the pouring with low superheat is realized.

27 Some problems as incorrect adjustment on the degree of superheat, general failure of the thermometer bulb, matching of the capacity and freezing of the TEV are presented.

28 The heated steam is then fed through the reminder of the turbine before being condensed. The reheat cycle incorporates an improvement in thermal efficiency over the superheat cycle.

29 It is illustrated that discharge temperature of gas cooler, efficiency of expander and degree of superheat at the inlet of compressor can exert more influence on the optimum high pressure.

30 With the increase of inlet air temperature of the condenser, evaporation pressure, condensation pressure increase, but supercooling and superheat degree, refrigerating capacity and COP decrease.