Random good picture Not show

1. Starch paste was pseudoplastic fluid.

2. PP/PP-R blends are pseudoplastic fluid. Melt viscosity of the melt promptly increased with increasing of the PP-R content.

3. However, the polymers are less pseudoplastic than LDPE, so melt viscosities are higher during processing.

4. The Newtonian PDMS turned to pseudoplastic at low shear rate region and the activation flow energy of compounding system was smaller than pure PDMS because of addition of filler.

5. Polyurethane melt is pseudoplastic fluid presenting shear-thinning property. B87 shows higher apparent viscosity than G83 at the same temperature.

6. Rice starch paste is pseudoplastic. The consistency coefficient of starch paste prepared by microwave is higher, but flow behavior index was lower, which shows its stickiness and softness are higher.

7. Results Both of carbomer gels were pseudoplastic fluids, and carbomer 934 gel was more sensitive to the influence of ions and organic solvents than carbomer 1342 gel.

8. The melt of blends exhibits the characteristics of pseudoplastic fluid.

9. The results showed that starch pastes owned pseudoplastic and the shear thinning characteristics,[sentencedict.com/pseudoplastic.html] the shear stability and heat stability were improved.

10. The results proved that the flowability of the system obeyed the law of pseudoplastic fluid.

11. An investigation into flow pattern of flow boiling heat transfer to highly viscous pseudoplastic fluids in vertical glass tubes with a transparent plating film was conducted.

12. The result shows that, with the increase of PA amount, pseudoplastic flow becomes unapparent and Binham flow becomes apparent.

13. The result also showed that IPI viscosity increased along with the IPI concentration increased, and indicated that the IPI solution was a non-Newtonian pseudoplastic fluid.

14. The results showed that: melt of PET synthesized with MTA is non-Newtonian pseudoplastic fluid.

15. The experimental results obtained revealed that waxy maize starch paste with pseudoplastic characteristics could be considered as a shear-thinning system.

16. The melt of EVOH/MMT composite is a type of pseudoplastic fluid, and the viscosity decreases with the increase of the shear rate, which is a shear-thinning phenomenon.

17. The rheological property of grafted products and PP was still a kind of non-Newtonian pseudoplastic fluid.

18. Rheology research found that the exopolysaccharide had self-viscosity-improvement and thixotropy, so the exopolysaccharide solution was a pseudoplastic liquid.

19. The paste properties of SSDS were tested, showing that SSDS had a good emulsion ability and stability and the SSDS paste displayed the character of pseudoplastic rheology.