Random good picture Not show

61 A device for protecting a semiconductor device from electrostatic discharge may include a high voltage first conductivity type well formed in a semiconductor substrate.

62 Zinc Oxide ( ZnO ) is a direct wild - gap semiconductor with n - type conductivity.

63 It is stressed that enhancing the effective thermal conductivity of the adsorber and decreasing the contact resistance are key technologies in this system.

64 Subsequently, a second polycrystalline silicon layer doped with a second conductivity type dopant is deposited to cover the first polycrystalline silicon layer.

65 The equivalent inductance and average magnetic conductivity of MS were involved in analysis of theory.

66 The results showed that electronic thermal conductivity had different effects on electronic maximum temperature, electron-phonon coupling time and electron-phonon coupling temperature.

67 The activation energy of conductivity in the orthorhombic phase was higher than that in the rhombic ; moreover, the activation energy dropped with Ca content increasing.

68 Thermal contact resistance and size effects are important factor for affecting effective thermal conductivity.

69 Applying conductivity and particle size analysis, the paper studied dissolution behaviors of chitosan in acetic acid.

70 Findings show that CB is a kind of electric loss medium and it has high electric conductivity and dielectric constants.

71 Through study the effect of carbon black filler content on conductivity, oil furnace carbon black with good economy and technology was selected.

72 The first epitaxial layer is disposed over the substrate and doped to have the first conductivity type as well.

73 The paper introduces the principle and construction of the transient hot-wire instrument, which has been used in measurement of the thermal conductivity for liquid with the most exact result.

74 The experimental results show that the polycrystalline iron fiber with high intrinsic permeability and low conductivity is favorable to the improvement of their microwave permeability.

75 A rapid method was built for the determination of sodium fluoroacetate in grains by capillary electrophoresis with high frequency conductivity detection (contactless conductivity detection).

76 Adding vinylene carbonate(VC) into electrolyte could enhance the conductivity and stability of anode surface.

77 The little carbon nanotube can improve impact strength, antistativity and electric conductivity of UHMWPE.

78 A second stack region may have a second conductivity type drift region, and a second conductivity type impurity region stacked in succession in the high voltage first conductivity type well.

79 Objective To explore the correlation between freezingpoint osmotic pressure and conductivity.

80 The contents and characteristics of the virtual experiment courseware of Determining the Coefficient of Heat Conductivity is introduced in detail.

81 Methods To determine the conductivity of156urine samples by Sysmex UF-100urinalyzer and osmotic pressure by algeoscopy.

82 The main influencing factors on electrolysis efficiency of the method were: oxide cathode conductivity, O2- diffusion, cathode potential,(www.Sentencedict.com) anode material.

83 Teflon pots of uniform heat , thermal conductivity fast, fast dissipation.

84 Rock wool carpet heat preservation is low thermal conductivity of a kind of high quality thermal insulation material.

85 Noctua solders the heat pipes to the cooling fins in order to assist the heat conductivity.

86 The coordination compounds we investigated by IR, DTG , TG and conductivity measurements.

87 He proposes to use the electrical conductivity of the sodium and chloride ions in seawater to create a novel type of Faraday cage.

88 Recent advances in capillary electrophoresis with contactless conductivity detection ( CE - CCD ) are reviewed with 68 references.

89 The well combination between Cu with preeminent conductivity and W with high-temperature strength and arc-resistance will yield a serial of preeminent properties.

90 The second desideratum, of low thermal and high electrical conductivity, was achieved by dividing the bismuth telluride into pellets a few nanometres across.