Sentencedict.com
 Directly to word page Vague search(google)
Home > Stator in a sentence

Stator in a sentence

  up(0)  down(0)
Sentence count:154Posted:2017-12-28Updated:2020-07-24
Similar words: testatorgustatoryrotatoragitatorimitatordictatorhortatoryspectatorMeaning: n. mechanical device consisting of the stationary part of a motor or generator in or around which the rotor revolves. 
Random good picture Not show
91. The quality requirement, control method and standard for stator cooling water of imported generator are described.
92. The paper introduces how to use multi station progressive die with high precision to manufacture stator core and rotor core of square stepping dynamotor .
93. The direct-current leakage test is implemented by using the microampere shielded in low-voltage, and the leakage current increasing of generator stator winding abnormally is detected.
94. Stator phase failure is one typical fault of a three-phase induction motor.
95. In addition, in order to avoid pure derivative operation on stator current, tracking-differentiator is adopted to acquire differential signals with high quality.
96. Furthermore, a checkout method for the third harmonic voltage based protection scheme of stator ground fault in generators is presented based on the verified MLM-FEM coupled model.
97. Heat degree 155 glass-polyester insulated wire and fused polyester and glass insulated wire are both new wires which are widely used as stator winding of large generator.
98. The contract states between the stator and the rotator of traditional ring type traveling wave USM is dynamic point-area contract, which lead to low output torque.
99. When the switched reluctance motors operate in two phase excitation mode, the phase flux linkage will be reduced due to the high magnetic saturation in the stator and the rotor yoke.
100. The generator stator winding parallel branches circulating current characteristics on air - gap eccentric fault were analyzed.
101. A mutual model reference adaptive method for the rotor speed and stator resistance identification is proposed in this paper to implement a speed sensorless direct torque control of induction motors.
102. The force factor formula of stator stuck with PZT pieces is deduced, and the relationship between input exciting voltage and output force is ascertained.
103. The stator component 8 is connected with an inarch stent 6, and the inarch stent is fixed at the car platform.
104. The paper checks the safety and stability of shoulder pole girder for hoisting large dynamotor stator with finite element software ANSYS.
105. To the special structure of submersible motor, the leakage reactance in end winding of stator and rotor are analyzed respectively.
106. U-I flux linkage model can be set exactly at low speed for considering the effects of temperature to stator resistance.
107. The on - line monitoring and diagnosis system for large generator stator windings partial discharge is presented.
108. On the basis of stator hollow conductor layer building in large electric machines,[www.Sentencedict.com] the paper deduces numerical formula for calculating conductor alternating current resistance.
109. It is the stationary part ( stator ) in a revolving - field generator.
110. The sampled stator voltages and currents were conversion to digital quantity and given to speed estimation system for estimating speed, then contrast it with the actual measured motor speed.
111. To improve the resolution of the frequency and the amplitude of fault feature component, the frequency subdivision and the adaptive filter are used in processing the steady current of stator.
112. This paper addresses itself to the inter - influence on the stator and rotor fault detection induction motors.
113. The variations of terminal voltage and stator frequency with the load impedance and the load current are given out.
114. The calibration of the apparent charge in the stator windings of electrical machines is relative to the location of PD site.
115. On the base of the reversibility analysis of the PMSM's mathematical model, the PMSM system is decoupled into a second-order linear speed subsystem and a first-order linear stator current subsystem.
116. The micromachining process like photolithograph, electroplate and sputtering etc is adopted to fabricate the stator of MGELR.
117. Then a vector control method with speed closed-loop and magnetic linkage closed loops put forward, which is based on the constant velocity by means of stator flux-oriented vector control.
118. The influences of gap length, polar arc and thick of stator yoke on electromagnetic torque are discussed.
119. The stator current is measured by using current whale, and then filtered.
120. Therefore, the model development in this paper starts from a consideration of basic stator coil and the basic loop that constitutes the rotor winding.
More similar words: testatorgustatoryrotatoragitatorimitatordictatorhortatoryspectatorcommutatornatatoriumcommentatorfacilitatordictatorialresuscitatordictatorshipstatutorysomatostatinspectator sportstatutorilystatutory lawsports commentatorstatutory rapestatute of limitationstatute of limitationspotatogatorsatorioratoraviatorhot potato
Total 154, 30 Per page  4/6  «first  pre  next  last»  goto
Leave a comment
Welcome to leave a comment about this page!
Your name:
Latest commentsInto the comment page>>
More words