Random good picture Not show

241. High pressure can significantly reduce the ignition delay and combustion period.

242. Phenol oxidation and catalyst - sorbent ignition may proceed bt different reaction mechanisms.

243. First, it closes and opens the circuit between the Battery and the ignition coil.

244. As a result of low heating value and unsteady component, ignition and combustion of Municipal Solid Waste(MSW) are difficult using conventional methods.

245. Description : Ruian Jiahang AutoAuto ignition switch, door lock, wiper connecting bar.

246. A test ignition system for two - stroke micro swing piston ICE is designed and realized.

247. Accurate air fuel ratio control is the key element for fuel economy(sentencedict.com), low emissions and good driveability of spark ignition(SI) engine.

248. Livermore has been pursuing the idea ever since with a succession of bigger and bigger lasers, culminating in the National Ignition Facility.

249. The misfired and uncompleted burned cycles increase during the preliminary process and the ignition delay is longer than warm start during transient process, so the HC and CO emissions rise.

250. Physicochemical properties and combustion mechanism of boron are introduced. Long ignition delay time and low combustion efficiency are due to the properties of boron itself.

251. "Her key fit not only my lock , but my ignition as well --so high-five for Toyota, I guess, " he said.

252. C ignition voltage and pulse ignition voltage has been made under the same operation condition of the cathode.

253. Choice main point: Shines the light should choose the temperature low energy conservation tube in the cloth skill, avoids the hyperpyrexia , the ignition fabric.

254. The new ignition system can use andas fuel and realizes igniting automation.

255. This system can be extended to realize the multi-center data acquisition, and the measurement of many-headed ignition coil.

256. Light off the pilot burner, with care not to exceed 15 sec. Max. in ignition time.

257. Using a combustion model some problems such as: the relationship between ignition delay and fuel concentration, the relationship between soot concentration and the equivalent ratio of mixt...

258. The design is based on a safe and convenient considering the gas ignition control system.

259. The signal read out of the sensor is to be filtered, amplified, shaped and synthesized and then transformed into a digital pulse one, which is equivalent to the ignition time delay.

260. With preheating SHS technology, by using preset detonator, the ignition apparatus in SHS reaction equipment can be cancelled, thus realizing industrial continous production.

261. The ancillary systems of plasma ignition are also involved in this paper.

262. The high plasma current allowed in a RFP is expected to be sufficient to heat the plasma to ignition without the need of auxiliary neutral-beam or radio-frequency heating.

263. The different plasma generator with different discharge efficiency is very important to performance of plasma ignition.

264. A motorcycle electric ignition system for guarding against theft was designed.

265. The paper presents the working principle, and operating mode of the system as well as the ignition control circuit.

266. If the ignition delay is too big, the propellants cant be burnt; if the ignition is too small, the improvement effects are small.

267. Based on the efficient control of waste spontaneous ignition at the head and tail of raw coal conveyor belt, review the methods and experiences.

268. The measurement and analysis of some experimental models revealed that the engine revolving speed bore a matching relationship to the electronic ignition system in an automobile.

269. A new generation fusion reactor will be needed after that to prove the next step, ignition.

270. In ignition control we mainly adapt the ignition ahead angel and the pulse wide of ignition according to the speed and load of engine.