Random good picture Not show

(211) The major sources of anthropogenic emissions of NO2 are combustion processes (heating, power generation, and engines in vehicles and ships).

(212) In the present chapter, the emphasis is mainly on lubricating oils for internal combustion engines.

(213) Simulation studies have been carried out on the cold blast distribution in the internal combustion stove of No. 4 BF at Anshan Iron and Steel Corp by application of 3-D fluid flow software.

(214) The results of the calculation and the analysis of effects of combustion chamber pressure, mixture ratio, propellant injection temperature and injector type on the combustion processes are reported.

(215) The intensification of combustion process is first discussed. Then, the structure, test and application of low-pulsating riser pipe burner are described.

(216) A perfectly stirred reactor model was adopted for its combustion chamber; and the steady quasi-1D isentropic flow was used for the nozzle flow.

(217) The influence of mechanical vibration is studied on SHS thermit combustion, ceramic solidification, as well as microstructure and properties of the static SHS process.

(218) Some basic danger parameters about zinc salt of pentachlorothiophenol(ZSPP), such as the property of combustion and explosion were seldom available from domestic and overseas literatures.

(219) In general, wet combustion is more effective than dry one since heat produced will be recycled more effectively to reduce fuel and air consumption, while recovery will still increase.

(220) Brown gas catalytic combustion technology can be widely used for various kind of waste incinerators.

(221) Based on the combustion characteristics of oxyhydrogen flame, a new flash-back arrestor faced on oxyhydrogen flame applied for oxyhydrogen welding and cutting equipment is designed.

(222) Combustion effects may cause unintentional interactions with the adjacent main flow environment.

(223) They researched membrane's dust dislodgment and properties, such as electrical conductivity, combustion and fatigue resistance, which is made from all kinds of fiber materials.

(223) Sentencedict.com is a online sentence dictionary, on which you can find nice sentences for a large number of words.

(224) As a result of low heating value and unsteady component, ignition and combustion of Municipal Solid Waste(MSW) are difficult using conventional methods.

(225) Our entire human society will be faced with a long-term problems that how to put combustion the most common energy conversion mode more efficient, less impacted to the environmental .

(226) Determinated micro - sulfur of potassium fluotantalate, Sensitivity of combustion - conductance method is 0.

(227) The combustion excitation for this more general case comes from more than one source.

(228) The units are completely self-contained and can be left unattended with no need for re-fueling or venting of combustion gases.

(229) When fuel supply advance angle is postponed too much, post combustion is longer and the combustion stability becomes worse.

(230) Such an emulsified resid provides good atomizing and combustion efficiency.

(231) Therefore, the process feed, combustion air, and fuel gas should be preheated as much as possible before considering steam generation in the convection section.

(232) If the combustion, just heat is let out to the fuel.

(233) Physicochemical properties and combustion mechanism of boron are introduced. Long ignition delay time and low combustion efficiency are due to the properties of boron itself.

(234) Sound Identification: Combustion knocks are divided into two classes: preignition and detonation.

(235) It puts forward an effective deep drawing technology about the alloy board with low-alloy and high-strength so that the properties of motor combustion chamber case satisfy with the needs of system.

(236) To lower the combustion pressure or increase the nitroglycerine content of the propellant can increase the critical value.

(237) The flame developing crank angle showed little variation with engine load and speed, while the rapid burning crank angle and total combustion crank angle decreased with the increase of bmep.

(238) The NOZZLE MIX burners feature short flames, wide turndown ranges and very stable combustion.

(239) The test shows that size distribution of feeding coal, volatile content and its release as well as the total air rate and primary air ratio will influence the post combustion in CFB boiler.

(240) Principle of nanometer catalyst preparation through reverse microemulsion method and its application in preparation of high temperature combustion catalyst were introduced.