Random good picture Not show

31. Mineral process of hematite in the early time often adopted gravity separation, and it mainly included jig, centrifugal separator, spiral chute, spiral concentrator, shaking table and so on.

32. Discuss with QE to make checking jig for critical dimensions.

33. The sword dance, similar to an Irish jig of a Highland fling, is usually performed at a Scottish wedding gathering.

34. Jig plates can be divided into fixed , hinged demountable and swing types.

35. An aligning jig to be fitted into the locating hole and the tapered portion is prepared.

36. He piped ( a jig ) so that we could dance.

37. In laboratory by using a model jig and a high-speed dynamic analysis meter, water flow in jig was observed and analyzed and a mass of data was obtained.

38. New jig design, low noise power Jiajin smooth, reliable, Mianweihu.

39. Model 6105T engine cylinder core setting jig, working steps of core setting jig and design pneumatic circuit of core setting jig have been introduced.

40. As soon as the jig was up, he flew of to Cairo.

41. Various design constructions of cores assembling jig for cylinder blocks was compared and analyzed.

42. The gray model forecasting theory and fuzzy control technology are introduced,[www.Sentencedict.com] and a new method based on gray model forecasting and fuzzy control of coal-feed in a jig is proposed in the paper.

43. The designed code is used in the practical jig management information system. It is so good effect for the succeed actualised of the system.

44. The jig design is to complete the structure plan, the assembly drawing and the parts drawing.

45. The dyeing residues of pad dyeing, over flow and the end vat of Jig dyeing could be decolorized and recycled by coagulant sedimentation.

46. Compared with the traditional jig using V-block, this jig is of simple structure and easy assembling.

47. With an industry standard bolt-hole pattern and router base diameter along with removable handles for insert plate clearance, the 5625-20 readily converts any existing table or production jig set-up.

48. Therefore has designed the lathe jig the drilling machine jig.

49. The design, manufacture and assembly of a high precise jig for machining keyway are introduced.

50. This design draft , mainly about the technological process of YTP26 Air-leg Rock Drill, and elabora about the milling machine typical jig design.

51. By designing and making the roll-over drill jig, the processing precision of hole is improved and work intensity is reduced.

52. Sawtooth wave jig dressing, except for very subtle material outside, almost can handle various size of mineral materials.

53. The paper mainly discusses the processing techniques of connecting rod and its jig design.

54. This paper introduces the hardware and firmware design of the MRI Table JIG by AVR microcomputer control. Also describes the precise control of table motion on lateral and longitude directions.

55. Pull out the jig dowel posts, get your hand into the sound hole and carefully peel away the cardboard jig.

56. Design and develop new jig, according to the production status.

57. Design new tools , jig & fixtures to improve line productivity.

58. Applied JT5-2 model saw tooth wave duplex jig to replace JT3-1 model single-chamber jig and spiral chutes which handle sand return from the double-spiral classifier, and achieved good index.

59. The process of cold rolling forming for outer ring of single freewheel of bicycle and the structure of roller and jig, and the parameters for rolling machine have been introduced.

60. It mainly introduces the technical method by which air jig uses tow conical surface to clamp sleeve parts locatedly.