Random good picture Not show

121. Because of nonlinear error in the mechanical transmission system, the control on the tensile force of yarn is unstable, the precision of transmission is low, and the dynamic response is dull.

122. Properties determined by mechanical testing, such as yield strength, ductility, ultimate tensile strength, hardness, bendability, impact strength, etc.

123. The tensile strength, modulus of elasticity(MOE) and hardness of Pinus massoniana fibers were determined by using zero-span tension and nanoindentation technique.

124. Therefore compared to the tensile anchor cable, the pressure anchor cable structure is more reasonable, higher bearing capacity and more safe and reliable.

125. Peak tensile radial strains occurred as vertical bands throughout the anulus, which may contribute to radial tears and herniations .

126. Then, the physical properties of periodate oxycellulose fibers were measured. These properties include dry tensile strength index, rewet tensile strength index, elongation, etc.

127. Moreover, in order to fulfill the tensile test of rat skin,(Sentence dictionary) we improved the two-axle tool microscope. The improvement provides the microscope with the basic ...

128. Layered fracture occurs after tensile test of high strength ship plate.

129. And a tensile constitutive relation of nickel foam containing strain rate and temperature is raised.

130. Ductile materials undergo considerable plastic tensile or shearing deformation before rupture.

131. Direct tensile, acceleration, and shock wave tests belong to the tensile test group, whereas adhesive tape, direct shear, peel and scratch tests belong to the shear test group.

132. The dough extensibility declines, and the maximum tensile resistance and extensile rate increase to some extent.

133. For example, the hole mobility in PMOS and the electron mobility in NMOS can be significantly enhanced by introducing appropriate compressive and tensile channel stresses, respectively.

134. The results showed that in the case of lithium ionomer, addition of zinc stearate lowered obviously the melt viscosity, and enhanced tensile strength of the ionomer.

135. Tensile stress was applied to the fiber prepreg to modify the residual stresses in ARALL during curing.

136. Both tensile strengths decrease when annealed at temperature higher than 920 ℃.

137. The evolution of deformation dislocation structure during the tensile loading was examined by transmission electron microscopy in the tempered martensite of low and middle carbon alloy steels.

138. It was found that tensile strength, pendulum hardness of the latex film cast from hybrid emulsion increased and water resistance became better with increasing the content of MMA.

139. The results showed that about 11% (weight fabrication) chopped fiber or 37% glass cloth reinforcing PTFE had the highest tensile strength and acceptable dielectric properties. Crystallizing phenome...

140. In the eastern area, the tensile strain is very intensive, while the compressive strain is very weak.

141. It is testified that the landfall happens because of the increase in shearing stress and tensile stress.

142. The fracture of the carbon fiber reinforced plumbum matrix composites in axial tensile was observed by the use of electron scanning microscopy.

143. On the premise that the tensile strength and the end quenching hardness don ′t decrease too much, the impact value can be greatly increased by increasing chromium content in composition range.

144. Tensile strength and hardness of caoutchouc modified by cenosphere were studied in order to explore cenosphere composite materials and improve some properties of composite materials.

145. In comparison to other leathers, deerskin offers comparatively high tensile strength.

146. Most metals have high tensile strength and high compressive strength.

147. The micro structures and tensile properties of HSLA steel in different relaxation time were studied.

148. The results indicate that the max tensile stress on the pavements appears on top of the U box which is near the loading area, and the max deformation appears on the center of the loading area.

149. RDH bleached pulp had relatively higher tear strength and lower tensile strength compared with traditional bleached sulfate pulp.

150. It is studied the ( lateral ) - torsional coupling vibration on the magnetic tensile force of a generator rotor.