Random good picture Not show

31) These resonance-enhanced shifts of the transmitted light beam may lead to potential applications in the optical devices, such as optical switch and optical coupler.

32) Using the temperature as the boundary condition field, the transient analysis of fiber coupler in the process of fused biconical taper was accomplished and stress-strain field was obtained.

33) Finally, the experimental result of a newly fabricated reflective single-mode fiber 8 port star coupler ... Sentencedict.com

34) A power-factor measurement instrument based on P89V51RD2 is designed, which uses optical coupler and specific LED drive chip.

35) Secondly, to deal with the problems in the experiments, the current foldback, optical coupler insulation and electromagnetic shielding were used to optimize the circuit performance of laser.

36) The directivity of microstrip coupler is worse than that of strip line coupler. Many methods can be used to improve this situation.

37) As the mutual isolation between input and output optical coupler, with one-way signal transmission characteristics, and therefore has good electrical insulation and anti-jamming capability.

38) In this case, recharge the batteries or use the DC coupler.

39) To deal with the problems in the experiment, the current foldback, optical coupler insulation and electromagnetic shielding was used to optimize the laser's performance.

40) Directional coupler is widely used in modern microwave system, how to test directional coupler's directivity with high directivity is a difficulty.

41) The HFED consists of bulb, power coupler and high - frequency generator . The power high - generator through feeder line.

42) An apparatus for optical body analysis is built with an illumination and detection head, and an optical coupler.

43) Involve , Directional Coupler , Shortplug, Adapter , Four Stabs Tune(sentencedict.com), Transformer etc.

44) Listed hydraulic coupler and fluid to stick the applied example of timing clutch.

45) Described are the structure composition, technical parameters and functions of CG - 5 coupler devices.

46) The coupling properties of Tee Junction coupler in a rectangular waveguide E plane are investigated using moment method and dyadic Green'sfunction theory.

47) We sum up the rule of the bistability with the change of coupler reflectivity and single-pass linear phase shift ?

48) Through analysis of sensor using the antenna model, it indicates that the radius and down-lead length of a disc coupler can influence frequency response characteristics.

49) The signal transmitting and receiving device is connected with an antenna or a rail signal coupler through a duplexer.

50) Topology line through the built-in switch or topology star through external switch, and this coupler has performance of auto-negotiation, auto-cross and full-duplex.

51) The selection and application of the hydrodynamic coupler and pneumatic clutch used in a mill as the smooth starting device were expounded.

52) Aerospace series - Elements of electrical and optical connection - Test methods - Part 704 : electrical elements - Measurement of turns ratio on a transformer used in a coupler.

53) Signal laser interferes in fiber coupler, then shaped signal pulse transmits from output port of this pulse shaper. Signal pulse′s waveform is determined by the profile of the nonlinear phase shift.

54) Notice: The explosion - proof telephone can be used normally only equipped with BHE coupler.

55) The linear optical coupler is the new photoelectricity device which is spreading in the world.

56) A study of the dynamic stability of an eccentric slider crank mechanism with elastic effects at both joints of the coupler is presented.

57) The optics principle and functions of fused polarization - maintaining fiber coupler is determined by propagation properties.

58) In some embodiments, a separate optical coupler can be used.

59) By properly setting the coordinate axis, the discrete data of a symmetric coupler curve is made to satisfy the conjugate symmetry.

60) The ceiling mount portion includes a mounting plate (32), a rod (33), and a cup-shaped coupler (34) .