Random good picture Not show

181. The entire circuit is mainly comprised of regulated power supply, preamplifier and power amplifier, among which LM4766 is a stereo audio amplifier using dual power supply application circuit.

182. The main hardware is composed of thermal resistor as temperature sensor, 87C51 single chip processor, as main control computer, together with amplifier and A/D transfer.

183. The shift trigger pulse of the thyristor trigger circuit with integration amplifier is generated by comparing directly principle of three-phase AC and shift-phase control voltage.

184. Can completely solve the long-distance transmission lines caused by the series amplifier, and the failure rate increased, the stability of the network poor.

185. The avalanche photodiode detector is followed by a front-end amplifier and equalizer or filter to provide gain as well as linear signal processing and noise bandwidth redution.

186. Technically speaking, you can have a a class AB single-ended amplifier, which was biased away from the linear portion of the curves, but that amplifier would (hopefully!

187. I have designed a kind of new variable gain linear pulse amplifier.

188. When using a single - supply amplifier , read the fine print!

189. Application of predistortion technology in CDMA2000 system is discussed in this paper. And a practical digital predistortion system is proposed to improve linearity and efficiency of power amplifier.

190. In modern power measurement, the measurement of the pulse of radio power has been widely used as the transmitter power, the delicacy of microwave receiver, the plus of amplifier and so on.

191. The reading circuit comprises at least one column amplifier (CA), and when the column amplifier is reset, a column amplifier reset signal is generated.

192. PRE, REC signal output for connecting the amplifier expediently and expand the sound field processing.

193. The amplification of highly chirped pulse with broadband in in homogeneously broadening amplifier is investigated.

194. As the amplifier tuned load circuit, they are able to select the base component cosine pulse to obtain undistorted amplification signal output, so this amp is also known as tuned power amplifier .

195. Based on its transfer characteristic, a new technique for reducing the nonlinearity of RF power amplifier is presented.

196. The front-end amplifier for optical receiver is made up of two important circuits: preamplifier and main amplifier.

197. This paper describes a self-bias S-band MMIC broad-band LNA(low noise amplifier) with high gain.

198. Learn tips from our stereo expert on choosing the right wire sizes for your car stereo amplifier in this free video clip on stereo systems.

199. Purpose: TV vertical output, audio output driver and general purpose amplifier applications.

200. A network synthesis method of microwave solid state power amplifier impedance matching circuit is introduced in this paper.

201. After comparing Linear Power Amplifier with PWM Power Amplifier, PWM Power Amplifier is selected as control signal's power amplifier part.

202. Receiver including the high-frequency amplifier, mixer circuit, demodulation circuit,[sentencedict .com] shaping circuit and decoding circuit.

203. The numerical model of the linear optical amplifier ( LOA ) is built based on the rate equations.

204. There is a lot more to good amplifier performance than output impedance.

205. This amplifier and crossover network drive the subwoofer mentioned above.

206. In this paper the nonlinear distortion AM - VSB CATV system with erbium - doped fiber amplifier ( EDFA ) was studied theoretically.

207. A physical model and related formulas for the calculation of small-signal gain and phase shift in a severed injected-beam crossed-field amplifier are presented in this paper.

208. This Paper describes theory to operate and composition of the image Light Amplifier of projector, also describes composition and Parameter of the projector.

209. The replica-amplifier gain enhancement technique is applied to improve the DC gain of the amplifier, which does not degrade the output swing and is very suitable for low-voltage applications.

210. Transistors are nonlinear devices, which can produce nonlinear distortion in amplifier while amplifying signals.