Random good picture Not show

31. Test results for the behavior of bond and slip between steel bar and concrete within a segment bounded by two primary cracks in a reinforced concrete tension member or a flexural member are presented.

32. Finally, the flexural ESMAA, outputting the same curvature with smaller prestrain , have longer cycle life and facilitate producing humanoid robot hand's finger.

33. In this paper, a longitudinal-flexural composite mode ultrasonic transducer composed of the sandwich longitudinal mode ultrasonic transducer and the flexural regular hexagon plate is studied.

34. This paper deals with the principle of measuring flexural rigidity of the fabrics by vibrating reed method. Floxural rigidity values of eight different fabrics were measured.

35. Subsynchronous Resonance is tested on the line which has series compensating capacitance. The test discovered that torsion vibration can restrain the complex motion of flexural vibration.

36. The poor compatibility of HGB with composite materials resulted in lower figures of the tensile strength, flexural strength and impact strength after adding HGB.

37. When it is used in the concrete reinforcement,(www.Sentencedict.com) the dispersed brucite fibers can play a better role in improving the concrete flexural strengths.

38. The tensile strength, impact strength, flexural strength, thermal properties and morphology of the composites were investigated.

39. By means of the Taylor expansion technique, the asymptotic expressions of the dispersion curves at the long wavelength region were derived for flexural and longitudinal vibration modes.

40. The dynamic deflection moduli of particleboard were measured by flexural vibration . longitudinal transmission and longitudinal vibration.

41. The calculation of flexural strength of reinforced concrete members in Code for Design of Concrete Structures (GB50010-2002) is the equivalent rectangle method based on the plane section assumption.

42. As is known to all , there are many biaxial flexural members on the civil engineering.

43. Glass fiber is used to reinforce material for increasing toughness, flexural strength, and tensibility in unsaturated polymer modified concrete.

44. It is mainly used in the strengthening of reinforced concrete flexural members and compression member with large eccentricity.

45. In the model, the flexural rigidity of rails, the rigidity of fastenings, the rigidity of subgrade, slide plate, guard rail and spacer block are taken into account.

46. Zirconia ceramics used in all-ceramic restoration of prosthodontics has shown favorable biocompatibility, chemical stability,[sentencedict.com] flexural strength and color property.

47. Tensile strength decreased, while the tensile break extension percentage increased first and then decreased, flexural properties was not sensible to the changing humiture.

48. Another method for calculating ultimate flexural capacity is presented which base on plane section assumption, and the reduced coefficient caused by slip is given.

49. Beam deflections were recorded during the test process. The experiment of residual flexural loading capacity of the beams was carried out after the preset time.

50. The attenuation factor of flexural wave in the pile is also analyzed.

51. The compoundtransducer is composed of the sandwich vibrator in longitudinal vibration and the circular thin plate in flexural vibration.

52. According to performance of carbon fiber and its application in engineering strengthening, the formula of plane section strength and shear strength of flexural members are put forward.

53. Often the test involves the measurement of the shear and flexural bond strength of a bonding agent or a comparison of bonding agents under varying environmental conditions.

54. Flexural Modulus of Elasticity —Alternate term for Modulus in Bending.

55. Key parts including piezoelectric transducer and amplitude transformer with a cylindrical hole in the center, and flexural vibration disk are analyzed and calculated.

56. Taken the lateral flexural rigidity of stiffener, the flexural rigidity in its plane and the torsional rigidity into consideration.

57. The flexural buckling and flexural-torsional buckling modes of a monosymmetric section column are presented and the equivalent slenderness ratio for flexural-torsional buckling is derived.

58. The bond and slip relationship between the rebar and the concrete within a segment bounded by two primary cracks in a reinforced concrete tension member or a flexural member is studied.

59. According to Mechanics theory the formulary of flexural rigidity, axial rigidity, shearing rigidity are deduced.

60. With theoretical method based on the assumption of plane section, the influence of steel reinforcement ratio, CFRP amount and initial loading level on the flexural strength is analyzed.