Random good picture Not show

31. Perform preparation of tensile and impact and bend sample , in addition, perform mechanical testing.

32. The result showed(1)The impact strength of untoughened PVC could be improved by PS, but resulting in a decrease of tensile strength at break.

33. The diffuse necking and localized necking in the tensile testing of sheet is proved through reseau strain analysis.

34. Study Design . uniaxial tensile loading study of 13 lumbar porcine ligaments under frying environmental temperature conditions.

35. We fabricated tilted buried stripe semiconductor optical amplifier by tensile strained InGaAs bulk active region.

36. In this study, a simple bending fixture was used to investigate the effects of tensile stress on the growth of NILC.

37. Round bar tensile tests of two Al-Zn-Mg-Cu Alloys (7010 and 7475) have been carried out in this investigation.

38. True or False: In all cases(sentence dictionary), nuts must have a proof load equal to the ultimate tensile of the screw used with any particular fastener grade.

39. Tensile test shall be carried out on one pipe sample representing each inspection lot. But not less than one pipe sample representing each heat test.

40. Mechanical tensile force arrives at retinal pigment epithelium via retinal neurosensory layer and has an effect on the functions of pigment epithelial cells.

41. When the surface braided angle is bigger, the stress-strain curve shows bilinear relation and tensile failure presents brittleness damage, respectively.

42. A row of Doric columns is not more authoritarian than a tensile structure is democratic.

43. Ductility . A ductile material is one which can be drawn out permanently by a tensile force.

44. The transverse stress of clad material was analyzed with the mixing rule, and the results show that the yield stress, tensile stress and the thickness ratio obey exponent function.

45. An experimental procedure and accompanying method for analyzing recorded data for deriving dynamic tensile strength and elastic modulus of brittle material is presented.

46. A ratchet spring provides tensile force to the ratchet pawl.

47. As the caprylic aldehyde content increased strain at break and tensile strength were decreased.

48. The Delingha diwa basin located at the Qaidam basin, s borderland is a tensile - compressive transfer zone.

49. The resistance, tensile strength and ductibility of formaldehyde's deposit were better than that from sodium hypophosphite solution.

50. The main factors such as pressure, the third invariant of stress tensor, strain hardening and softening, stain rate and tensile damage have been taken into account in the constitutive model.

51. In a certain range, the tensile strength of composite increases with increasing volume fraction of modified carbonyl iron powder.

52. Pipeline steel adopting the spicular ferrite owns the better properties of forming and anti corrosion for its low ratio of yield strength and tensile strength and uniform microstructure.

53. So it is feasible to study the deformation behavior of sheet metals along different loading paths by using biaxial tensile test of cruciform specimen with slots on arms designed in this paper.

54. AIM:To compare the compressive strength, tensile strength and flexural strength of bulkily filled and incrementally filled visible light-cured composite resin.

55. In particular, the soft glass, impact resistance, tensile characteristics , not only to ensure its long life, more important is not to harm the human body.

56. The morphology of multiphase complex structure low alloy structural steel and its tensile property were studied.

57. The cylinder head is attached to the block with high - tensile steel studs.

58. But it is better than the leading-products of synthetic rubber-SBR polybutadiene rubber in tear strength tensile strength and tackiness .

59. It was founded out to fit the heat resistant process of the fluoroelastomer by a lot of tests and measuring the physical properties tests(tensile strength, elongation at break and hardness).

60. The character of few knots, high tensile and abrasion resistence is famous in the customers.